Frigo Notes on use
23
Figure 12: Standby cooling control unit with Reset button
➤ After a short waiting time, press the Reset switch on the control unit into
position 1.
➤ Plug the standby cooling mains plug into the socket.
I
8 Notes on use
8.1 Notes on correct loading
Before you start loading the vehicle, the loading area must be cooled
down to the correct temperature level and must be loaded only with
properly chilled goods in order to maintain a continuous chain of refriger-
ation.
Figure 13: Air circulation in the cooling area
NOTE
If the acoustic signal continues to sound, repeat this procedure.
If this does not rectify the problem, please contact our service hotline
(see chapter “Service hotline” on page 27).
&RQWUROXQLW
ResetVZLWFK
$LUFLUFXODWLRQ *RRGV
(YDSRUDWRU &RROLQJ
)ULJR2VERRN6HLWH'RQQHUVWDJ)HEUXDU
To Next Page
Loading...
