Dometic Frigo - Switching the Cooling System On

EN
Frigo Operation
9
5.2 Switching on the cooling system
!
A
➤ Switch on the ignition.
➤ Start the engine.
➤ Turn off the automatic start/stop system if present.
Refer to the operating manual for your vehicle for information on the use and func-
tion of the automatic start/stop system.
➤ After the loading indicator lamp of your vehicle has gone out, press .
Figure 2: Switching on the cooling system, control test
✓ Before switching on the cooling system, the control unit performs a check to
ensure that the system is working properly. All symbols are indicated on the dis-
play for a few seconds.
CAUTION!
Make sure that the 220 V mains connection cable of the standby cooling
(additional equipment) is not connected!
NOTICE!
The cooling system remains activated when the vehicle ignition is
switched off and the ignition key is removed.
SET
)ULJR2VERRN6HLWH'RQQHUVWDJ)HEUXDU