3. Put each cable/grommet into the seal and re-assemble the seal.
4. Install the seal on the cover.
5.
Connect the cables to the controller's electrical connectors and re-install the cover.
CAUTION Risk of equipment damage.
To ensure cables are not pulled out when the cover is removed, check the cables
have enough length between the internal seal and controller's electrical
connectors.
If the cables are too short, the cables and controller may be damaged by pulling,
when the cover is removed.
INSTALLATION
33 EPT053091 - Issue 5 - 07 May 2021
To Next Page
Loading...