Dormakaba ED100LE - Cover End Cap and Spindle Installation; Install Door Signage, Low Energy Door; Cover, End Caps and Spindle Caps; Install Door Signage

37
ED100LE 02-2021DL4616-001
dormakaba ED100LE operator – Fine cover
Installation Instructions
Chapters 12, 13 and 14
"D" door width,
inches [mm]
"W" door weight, pounds [kg]
 [.]  [.]  []  [.]  [.]
 [] . . . . .
 [] . s . s . s . s . s
Minimum opening time to back check or  degrees (whichever occurs first).
Minimum closing time from  degrees to latch check or  degrees (whichever occurs
first).
.. A., Table I: Minimum opening and closing times.
.. A., Table II: Total opening time to  degrees.
Back check at ° Back check at ° Back check at °
Table I plus  s Table I plus . s Table I plus  s
If door opens more than °, it shall continue at the same rate as backcheck speed.
Back check occurring at a point between positions shall use lowest setting.
.. Other door weights and widths.
Closing time T = (D
W
)/
D = Width of door in inches.
W = Weight of door in pounds.
T = Closing time to latch check in seconds.
SI (metric) units
Closing time T = (D
W
)/
D = Width of door in mm.
W = Weight of door in kg.
T = Closing time to latch check in seconds.
 Install door signage, low energy door
. Install door signage
.. Install door signage.
Install applicable door signage as outlined in Chapter ,
EDLE door signage.
 Cover, end caps and spindle caps
. Cover end cap and spindle installation
.. Cover and end cap installation.
Cover and end caps will be installed after EDLE
operator setup is completed.
• Reference EDLE/EDLE Setup Manual.