Dormakaba ED100LE - Arm Fasteners - Torque Requirements

39
ED100LE 02-2021DL4616-001
dormakaba ED100LE operator – Fine cover
Installation Instructions
Chapter 15
Fig. 15.2.1 Arm M8 SHCS cap
8 Cap
Fig. 15.2.2 M8 SHCS
8
5
. Arm fasteners – torque requirements
.. Check drive arm M SHCS torque.
1. Set program switch to CLOSE.
. Remove cap over M SHCS.
. Check torque.
. Replace cap.
CAUTION
Using torque wrench with  mm
hex key socket, check M SHCS
torque:  ft-lb [ Nm].
.. Check pivot pin M socket head
torque.
. Check torque.
CAUTION
Use torque wrench with hex key
socket. M screw torque:
. - . ft-lb [ -  Nm].
Fig. 15.2.3 Pivot pin M8 socket head
3 Pivot pin M8
socket head
3
5 M8 x __ SHCS