Page 4-12 Infinity Gamma Series VF4
NOTES:
! The Transfer Bed menu displays all networked beds in the
selected care unit that are currently in Standby mode.
! You must click on a bed label, even if there is only one avail-
able bed listed in the transfer menu; if you do not select a bed,
the transfer cannot take place.
! If a previous patient had not been discharged at the destination
monitor before data transfer, the discharge takes place automat-
ically during transfer and all previous patient data is deleted.
7. Click on Start Transfer.
8. Click on
Confirm to start the transfer.
During transfer, the Transfer menu displays the status message
Transferring data. Once the transfer is complete, the patient is
automatically discharged from the source monitor and admitted
to the destination monitor.
If the transfer is interrupted or unsuccessful, the destination mon-
itor displays a transfer error message. In this case, the source
monitor retains its data and you can attempt the transfer again.
To Next Page
Loading...
