Page 5-16 Infinity Gamma Series VF4
Messages
The monitor displays the following types of messages:
! Alarm messages to alert you to a physiological condition
(e.g., Asystole).
! Status messages to alert you to faults and their causes (e.g.,
RA Lead Off) or to follow the work-in-progress of your mon-
itor (e.g., Alarm Recording Started).
! Diagnostic messages to alert you to hardware and software
conditions (e.g., Low Battery Reset).
! Network messages (including Alarm Group messages) to
alert you to network operating conditions (also see the chap-
ter Network Applications).
The monitor displays alarm messages according to their alarm
grade on a red, yellow or white background in the message area
(e.g., Asystole) and in the parameter box (e.g., ASY).
The monitor displays status and network messages in the message
area at the bottom of the screen.
Diagnostic messages appear during the self-test routines that
occur immediately after you turn the monitor on.
Alarm and most status and network messages appear alternately
until the condition has been resolved. Diagnostic messages and
some status and network messages appear only once.
Whenever possible, Dräger recommends that you check the
equipment and the accessories carefully before monitoring your
patient to eliminate faulty conditions. Careful patient preparation
will also eliminate most common error conditions.
WARNIN G: Do not operate the monitor if you detect
any equipment malfunction. In this case, take the unit out
of operation and call your Biomed or DrägerService.
To Next Page
Loading...
