Dräger Polytron 8200 CAT / Dräger Polytron 8310 IR
Menu overvi ew
Ż
Back to
measure
Information Instrument
Warnings
Sensor
Faults
Calibration Data logger
Device flags
Modules
Settings
Last cal. date
Zero calibration
Next cal. date
Span calibration
Alarm on/off
Auto calibration
Logger status Relay A1
Graph Relay A2
SIL activation
Alarm A1
Instrument
Alarm & relays Alarm A2
Communication
Passwords Fault warm-up
Sensor
Date and time Set alarm A1
Data logger
Language Set alarm A2
Function key Set fault
Device init
Datalogr. on/off
SW dongle Calibration PWD
Data logger
Bump test Settings PWD
Clear datalogger
Display
Display contrast
Display mode
Sample time
Display test
Peak/Average
Trigger on/off
Polling address
Trigger value
Unique identifier
Stack/Roll
Tag
HART interface Dräger REGARD
Analog interface
Modbus Fault current
Profibus address Warning
Warning interval
Auto calibration Warning current
Sensor type Maint. signal
Gas settings Maint. current
Init channel Beamblock on/off
Cal. interval Beambl. current
Fast response Beamblock limit
Display capture Analog offset
DSIR category Analog span
DD sensor latching Set current
Set concentr.
Set fault
Set warning
Set mainten.
Set beamblock
Modbus address
Modbus baudrate
Modbus parity
To Next Page
Loading...
Need help?
General
