Technical Manual | Dräger Polytron
®
8000 Series 9
Safety-related information
2 Safety-related information
Before using this product, carefully read the associated instructions for use. This
document does not replace the instructions for use.
2.1 Safety statements
– Before using this product, carefully read these Instructions for Use and those of
the associated products.
– Strictly follow the instruction for use. The user must fully understand and strictly
observe the instructions. Use the product only for the purposes and under the
conditions specified in this document.
– Comply with all local and national laws, rules, and regulations associated with
this product.
– Only trained and competent personnel are permitted to inspect, repair and
service the product as detailed in these instructions for use. Further
maintenance work that is not detailed in these instructions for use must only be
carried out by Dräger or personnel qualified by Dräger.
– Dräger recommends a Dräger service contract for all maintenance activities and
that all repairs are carried out by Dräger.
– Use only genuine Dräger spare parts and accessories. Otherwise the proper
functioning of the product may be impaired.
– Do not dispose of the Instructions for Use. Ensure that they are retained and
appropriately used by the product user.
– Only trained and competent users are permitted to use this product.
– Maintenance must be performed as described, see 11 Maintenance.
– Only operate the product within the framework of a risk-based alarm signaling
concept.
– Before connecting this instrument to electrical devices not mentioned in the IFU
consult Dräger
– Notify Dräger in the event of any component fault or failure.
– The instruments or components may not be modified in any manner.
– The use of faulty or incomplete parts is forbidden.
– The appropriate regulations must be observed at all times when carrying out
repairs on these instruments or components.
– Follow the directions of EN 60079-29-2 for the measurement of flammable
gases and oxygen.
– Follow the directions of EN 45544-4 for the measurement of toxic gases.
Polytron
®
8100 EC-specific:
– WARNING: Risk of ignition of flammable or explosive atmospheres! Substitution
of components may impair Intrinsic Safety.
2.2 Operating area and conditions
– For SIL applications observe the Polytron
®
8xx0 Safety Manual.
– When exposed to a directed flow of air mixed with gas, the measured values can
be increased. See the corresponding sensor data sheet for deviation values.
To Next Page
Loading...
Need help?
General
