Dräger Polytron 8000 Series Technical Manual

96 Technical Manual | Dräger Polytron
®
8000 Series
Accessories and spare parts
19.5.1 Sensors
Check firmware compatibility of sensor and transmitter. Changing the sensor may
require a firmware update. For support, contact Dräger.
Process cuvette PIR 7000 Stainless
Steel
6811415
Process adapter PIR 7000 SGR 6813219
Status Indicator PIR 7000 / 7200 6811625 / 6811920
Splash Guard PIR 7000 / 7200 6811911 / 6811912
Flow Cell PIR 7000 / 7200 6811490 / 6811910
Bump Test Adapter PIR 7000 / 7200 6811630 / 6811930
Insect Guard PIR 7000 6811609
Hydrophobic Filter PIR 7000 6811890
Calibration Adapter PIR 7000 6811610
Process adapter PIR 7000 / 7200 POM
(Polyoxymethylene)
6811915
1) Check firmware compatibility of sensor and transmitter. Changing the PCB may require a firm-
ware update. For support, contact Dräger.
Description Part Number
Description Part number
Dräger PIR 7000 Type 334 (NPT) 6811822
Dräger PIR 7000 Type 340 (NPT) 6811832
Dräger PIR 7000 334 (M25)
complete set
6811825
Dräger PIR 7000 340 (M25)
complete set
6811819
Dräger PIR 7200 (NPT) 6811572
Dräger PIR 7200 (M25) HART, complete
set
6812290

Dräger Polytron 8000 Series Specifications

General

Ingress Protection	IP66/67
Detection Principle	Electrochemical, Infrared, Catalytic Bead
Gases Detected	Combustible gases, toxic gases, and oxygen
Display	LCD with backlight
Humidity Range	0 to 99% RH (non-condensing)
Housing Material	Stainless steel
Output Signal	4-20 mA, HART, RS-485 Modbus
Power Supply	10 to 30 V DC
Certifications	ATEX, IECEx, CSA
Temperature Range	-40 °C to +65 °C (depending on sensor)