Dräger Polytron 8000 Series Technical Manual

94 Technical Manual | Dräger Polytron
®
8000 Series
Accessories and spare parts
19 Accessories and spare parts
This chapter gives an overview of the main parts that are covered by the BVS 13
ATEX G 001 X and PFG 14 G 001 X type examination. For other parts refer to the
spare parts list or contact DrägerService.
19.1 Polytron
®
8xx0
19.2 Polytron
®
8100 EC
19.2.1 DrägerSensor AC
19.3 Polytron
®
8200 CAT
Description Part Number
IRDA to PC interface 4544197
Magnetic wand with key chain 4544101
Dräger PolySoft Configuration Software 8328600 / 8328639
Exd blind plug stainless steel 4544321
Exd blind plug galvanic steel 6812269
Description Part Number
PCB unit Polytron 8100 4-20/HART 4544781
PCB unit Polytron 8100 4-20/HART,
Relay
4544782
Bayonet ring 4544366
Duct mount adapter for EC Sensing
Head Remote
1)
1) May have an influence on measurement performance, i.e. increasing the response time. Not
covered by BVS 13 ATEX G 001 X.
8317617
Pole mount kit for EC Sensing Head
Remote
4544213
Sensor test dongle 8317619
Diagnostic dongle 8317860
Calibration adapter PE, Europe 6806978
Description Part number
DrägerSensor
®
AC
6810595
Splashguard 6809379
Calibration adapter 8324093
Description Part Number
PCB unit Polytron 8200
4-20/HART
4544788
PCB unit Polytron 8200
4-20/HART Relay
4544789

Dräger Polytron 8000 Series Specifications

General

Ingress Protection	IP66/67
Detection Principle	Electrochemical, Infrared, Catalytic Bead
Gases Detected	Combustible gases, toxic gases, and oxygen
Display	LCD with backlight
Humidity Range	0 to 99% RH (non-condensing)
Housing Material	Stainless steel
Output Signal	4-20 mA, HART, RS-485 Modbus
Power Supply	10 to 30 V DC
Certifications	ATEX, IECEx, CSA
Temperature Range	-40 °C to +65 °C (depending on sensor)