Dräger Polytron 8000 Series Technical Manual

Technical Manual | Dräger Polytron
®
8000 Series 21
Installation
Dimensions of the duct
– Wall thickness  4 mm / 0.15’’
–Diameter  100 mm / 4’’
5.1.2.2 Duct Mount Kit Polytron
®
87x0 IR
For installation instructions refer to 9033236.
Dimensions of the duct
–Diameter  200 mm / 8’’
– rectangular cross-section  170 x 170 mm / 6.7" x 6.7".
5.2 Electrical installation
For recommended tightening torques and admissible wire specifications see
17 Technical data.
4482844827

Dräger Polytron 8000 Series Specifications

General

Ingress Protection	IP66/67
Detection Principle	Electrochemical, Infrared, Catalytic Bead
Gases Detected	Combustible gases, toxic gases, and oxygen
Display	LCD with backlight
Humidity Range	0 to 99% RH (non-condensing)
Housing Material	Stainless steel
Output Signal	4-20 mA, HART, RS-485 Modbus
Power Supply	10 to 30 V DC
Certifications	ATEX, IECEx, CSA
Temperature Range	-40 °C to +65 °C (depending on sensor)