Vigor2860 Series User’s Guide
157
Source IP
Any – Any IP can be treated as the source IP.
Src IP Start - Type the source IP start for the specified
WAN interface.
Src IP End - Type the source IP end for the specified
WAN interface. If this field is blank, it means that all the
source IPs inside the LAN will be passed through the WAN
interface.
Destination IP
Any – Any IP can be treated as the destination IP.
Dest IP Start- Type the destination IP start for the
specified WAN interface.
Dest IP End - Type the destination IP end for the specified
WAN interface. If this field is blank, it means that all the
destination IPs will be passed through the WAN interface.
Destination Port
Any – Any port number can be treated as the destination
port.
Dest Port Start - Type the destination port start for the
destination IP.
Dest Port End - Type the destination port end for the
destination IP. If this field is blank, it means that all the
destination ports will be passed through the WAN interface.
Send to if criteria
matched
Interface – Use the drop down list to choose a WAN or
LAN interface or VPN profile. Packets match with the
above criteria will be transferred to the interface chosen
here.
Gateway IP – Specific gateway is used only when you
want to forward the packets to the desired gateway.
Usually, Default Gateway is selected in default.
Priority
Packets will be transmitted based on all routes or Route
Policy. Vigor router will determine which rule will be
adopted for transmitting the packet according to the priority
of Static Route and Route Policy.
The greater the value is, the lower the priority is. Default
value for route policy is “200” which means it has higher
priority than the default route.
More options
Packet Forwarding to WAN via – When you choose
WAN (e.g., WAN1) as the Interface for packet
transmission, you have to specify the way the packet
forwarded to. Choose Force NAT or Force Routing.
Failover to – Check this button to lead the data passing
through specific interface (WAN/LAN/VPN/Route Policy)
automatically when the selected interface (defined in Send
via if criteria matched) is down.
WAN/LAN – Use the drop down list to choose an
interface as an auto failover interface.
VPN – Use the drop down list to choose a VPN tunnel
as a failover tunnel.
Route Policy – Use the drop down list to choose an
existed route policy profile.
To Next Page
Loading...
Need help?
General
