Vigor2860 Series User’s Guide
81
3
3
.
.
1
1
.
.
2
2
G
G
e
e
n
n
e
e
r
r
a
a
l
l
S
S
e
e
t
t
u
u
p
p
This section will introduce some general settings of Internet and explain the connection modes
for WAN1, WAN2 and WAN3/WAN4 in details.
This router supports multiple-WAN function. It allows users to access Internet and combine
the bandwidth of the multiple WANs to speed up the transmission through the network. Each
WAN port can connect to different ISPs, Even if the ISPs use different technology to provide
telecommunication service (such as DSL, Cable modem, etc.). If any connection problem
occurred on one of the ISP connections, all the traffic will be guided and switched to the
normal communication port for proper operation. Please configure WAN1, WAN2, WAN3
and WAN4 settings.
This webpage allows you to set general setup for WAN1, WAN2, WAN3 and WAN4
respectively. In default, WAN2 is disabled. If you want to enable it, simply click the WAN2
link and select Yes in the field of Enable.
Available settings are explained as follows:
Item Description
Load Balance Mode
This option is available for multiple-WAN for getting
enough bandwidth for each WAN port. If you know the
practical bandwidth for your WAN interface, please choose
the setting of According to Line Speed. Otherwise, please
choose Auto Weigh to let the router reach the best load
balance.
Index
Click the WAN interface link under Index to access into the
WAN configuration page.
Enable
V means such WAN interface is enabled and ready to be
used.
To Next Page
Loading...
Need help?
General
