Vigor2860 Series User’s Guide
644
UsbPrintReady=0, UsbIsPrinting=0
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
q
q
o
o
s
s
s
s
e
e
t
t
u
u
p
p
This command allows user to set general settings for QoS.
qos setup [-<command> <parameter> | ... ]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
[<command>
<parameter>|…]
The available commands with parameters are listed below.
[…] means that you can type in several commands in one
line.
-h
Type it to display the usage of this command.
-m <mode>
It means to define which traffic the QoS control settings
will apply to and eable QoS control.
0: disable.
1: in, apply to incoming traffic only.
2: out, apply to outgoing traffic only.
3: both, apply to both incoming and outgoing traffic.
Default is enable (for outgoing traffic).
-i <bandwidth>
It means to set inbound bandwidth in kbps (Ethernet WAN
only)
The available setting is from 1 to 100000.
-o <bandwidth>
It means to set outbound bandwidth in kbps (Ethernet WAN
only). The available setting is from 1 to 100000.
-r <index:ratio>
It means to set ratio for class index, in %.
-u <mode>
It means to enable bandwidth control for UDP.
0: disable
1: enable
Default is disable.
-p <ratio>
It means to enable bandwidth limit ratio for UDP.
-t <mode>
It means to enable/disable Outbound TCP ACK Prioritize.
0: disable
1: enable
-V
Show all the settings.
-D
Set all to factory default (for all WANs).
[…]
It means that you can type in several commands in one line.
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> qos setup -m 3 -i 9500 -o 8500 -r 3:20 -u 1 -p 50 -t 1
WAN1 QOS mode is both
Wan 1 is XDSL model ,don,t need to set up
Wan 1 is XDSL model ,don,t need to set up
To Next Page
Loading...
Need help?
General
