Draytek Vigor2860 Series - Telnet Command: Ip6 Dhcp Server

Vigor2860 Series User’s Guide
596
client
It means the dhcp client settings.
[<command>
<parameter>|…]
The available commands with parameters are listed below.
[…] means that you can type in several commands in one
line.
-a
It means to show current DHCPv6 status.
-p [IAID]
It means to request identity association ID for Prefix
Delegation.
-n [IAID]
It means to request identity association ID for
Non-temporary Address.
-c [parameter]
It means to send rapid commit to server.
-i [parameter]
It means to send information request to server.
-e[parameter]
It means to enable or disable the DHCPv6 client.
1: Enable
0: Disable
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> ip6 dhcp client WAN2 –p 2008::1
> ip6 dhcp client WAN2 –a
Interface WAN2 has following DHCPv6 client settings:
DHCPv6 client enabled
request IA_PD whose IAID equals to 2008
> ip6 dhcp client WAN2 –n 1023456
> ip6 dhcp client WAN2 –a
Interface WAN2 has following DHCPv6 client settings:
DHCPv6 client enabled
request IA_NA whose IAID equals to 2008
> system reboot
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
i
i
p
p
6
6
d
d
h
h
c
c
p
p
s
s
e
e
r
r
v
v
e
e
r
r
This command allows you to configure DHCPv6 server.
ip6 dhcp server [-<command> <parameter>| ... ]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
server
It means the dhcp server settings.
[<command>
<parameter>|…]
The available commands with parameters are listed below.
[…] means that you can type in several commands in one
line.
-a
It means to show current DHCPv6 status.
-<pool_min_addr>
It means to set the start IPv6 address of the address pool.
-x<pool_max_addr>
It means to set the end IPv6 address of the address pool.
-d<addr>
It means to set the first DNS IPv6 address.