Draytek Vigor2860 Series User Manual

Vigor2860 Series User’s Guide
598
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
i
i
p
p
6
6
i
i
n
n
t
t
e
e
r
r
n
n
e
e
t
t
This command allows you to configure settings for accessing Internet.
ip6 internet -W n -M n [-<command> <parameter> | ... ]
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
-W n
W means to set WAN interface and n means different
selections. Default is WAN1.
n=1: WAN1
n=2: WAN2
n=3: WAN3
.
.
n=X: WANx
-M n
M means to set Internet Access Mode (Mandatory) and n
means different modes (represented by 0 – 5)
n= 0: Offline,
n=1: PPP,
n=2: TSPC,
n=3: AICCU,
n=4: DHCPv6,
n=5: Static
n=6:6in4-Static
n=7:6rd
[<command>
<parameter>|…]
The available commands with parameters are listed below.
[…] means that you can type in several commands in one
line.
-m n
It means to set IPv6 MTU.
N = any value (0 means “unspecified”).
-u <username>
It means to set Username.
<username>= type a name as the username (maximum 63
characters).
-p <password>
It means to set Password.
<password> = type a password (maximum 63 characters).
-s <server>
It means to set Tunnel Server IP.
<server>= IPv4 address or URL (maximum 63 characters).
-d <server>
It means to set the primary DNS Server IP.
<server>= type an IPv6 address for first DNS server.
-D <server>
It means to set the secondary DNS Server IP.
<server>= type an IPv6 address for second DNS server.
-t <dhcp/ra/none>
It means to set IPv6 PPP WAN test mode for DHCP or
RADVD.
<dhcp/ra/none>= type IPv6 address.

Draytek Vigor2860 Series Specifications

General

Firewall Type	Stateful Packet Inspection (SPI)
VPN Support	IPSec, PPTP, L2TP, SSL VPN
DoS Protection	Yes
Intrusion Prevention System (IPS)	Yes
LAN Interfaces	4 x Gigabit Ethernet
User Authentication	Local, RADIUS, LDAP
VPN Tunnels	32
Management Interface	Web-based, CLI
Concurrent Sessions	50, 000
Content Filtering	URL Keyword Filtering, Web Content Filtering