Draytek Vigor2860 Series User Manual

Vigor2860 Series User’s Guide
161
Example 2:
Below shows a scenario that local users behind Vigor router A want to access into a remote
service (e.g., YouTube) which is blocked or restricted by local Service Provider in their
country (e.g., UK in this case). A policy route can be created by the side of Router A to break
through the Internet censorship circumvention.
A VPN tunnel has been established between Router A and router B.
1. Access into the web user interface of Router A.
2. Open Load-Balance/Route Policy.
3. Click any index number (e.g., #1 in this case).
4. In the following web page, check Enable; type “192.168.1.10” as Src IP Range; type
“213.57.89.100” as the Destination IP for the remote VPN server; and choose VPN as
the Interface setting.

Draytek Vigor2860 Series Specifications

General

Firewall Type	Stateful Packet Inspection (SPI)
VPN Support	IPSec, PPTP, L2TP, SSL VPN
DoS Protection	Yes
Intrusion Prevention System (IPS)	Yes
LAN Interfaces	4 x Gigabit Ethernet
User Authentication	Local, RADIUS, LDAP
VPN Tunnels	32
Management Interface	Web-based, CLI
Concurrent Sessions	50, 000
Content Filtering	URL Keyword Filtering, Web Content Filtering