Vigor2860 Series User’s Guide
352
number you choose, using digits 0-9 and * .
Display Name
The Caller-ID that you want to be displayed on your
friend’s screen. This let your friend can easily know who’s
calling without memorizing lots of SIP URL Address.
SIP URL
Enter your friend’s SIP Address.
Dial Out Account
Choose one of the SIP accounts for this profile to dial out. It
is useful for both sides (caller and callee) that registered to
different SIP Registrar servers. If caller and callee do not
use the same SIP server, sometimes, the VoIP phone call
connection may not succeed. By using the specified dial out
account, the successful connection can be assured.
Loop through
Choose PSTN to enable loop through function.
Backup Phone Number
When the VoIP phone is obstructs or the Internet breaks
down for some reasons, the backup phone will be dialed out
to replace the VoIP phone number. At this time, the phone
call will be changed from VoIP phone into PSTN call
according to the loop through direction chosen. Note that,
during the phone switch, the blare of phone will appear for
a short time. And when the VoIP phone is switched into the
PSTN phone, the telecom co. might charge you for the
connection fee. Please type in backup phone number for
this VoIP phone setting.
After finishing all the settings here, please click OK to save the configuration.
Note: If the incoming or outgoing calls do not match any entry on the phonebook, the
router will try to make the call "being protected". But, if the call ends up "unprotected"(e.g.
peer side does not support ZRTP+SRTP), the router will not play out a warning message.
To Next Page
Loading...
Need help?
General
