Draytek Vigor2860 Series User Manual

Vigor2860 Series User’s Guide
368
automatically on the page. If you cannot find out a suitable
one, please choose User Defined and fill out the
corresponding values for dial tone, ringing tone, busy tone,
congestion tone by yourself for VoIP phone.
Also, you can specify each field for your necessity. It is
recommended for you to use the default settings for VoIP
communication.
Volume Gain
Mic Gain (1-10)/Speaker Gain (1-10) - Adjust the volume
of microphone and speaker by entering number from 1- 10.
The larger of the number, the louder the volume is.
MISC
Dial Tone Power Level - This setting is used to adjust the
loudness of the dial tone. The smaller the number is, the
louder the dial tone is. It is recommended for you to use the
default setting.
Call Waiting Tone Power Level - This setting is used to
adjust the loudness of the call waiting tone. The smaller the
number is, the louder the tone is. It is recommended for you
to use the default setting.
Interdigit Timeout –Type a value in this field to specify
time limit for interdigit.
DTMF
DTMF Mode – There are four DTMF modes for you to
choose.
 InBand - Choose this one then the Vigor will send the
DTMF tone as audio directly when you press the

Draytek Vigor2860 Series Specifications

General

Firewall Type	Stateful Packet Inspection (SPI)
VPN Support	IPSec, PPTP, L2TP, SSL VPN
DoS Protection	Yes
Intrusion Prevention System (IPS)	Yes
LAN Interfaces	4 x Gigabit Ethernet
User Authentication	Local, RADIUS, LDAP
VPN Tunnels	32
Management Interface	Web-based, CLI
Concurrent Sessions	50, 000
Content Filtering	URL Keyword Filtering, Web Content Filtering