9 | System setup menu 3
D-ISC 100 x xx2
95
After calling up (
) the firmware update, you are guided
through the update process step by step.
Menu: 3.6
Status: S1.3:Normal measurement
System setup
Date / Time
DURAG-Modbus
Backup / Restore
Firmware update
Language
Device description update
E
Fig.9.8: Firmware update I
The firmware update starts after pressing the
key to confirm.
Firmware update
Status: S1.3:Normal measurement
Menu: 3.6
Please press RETURN key to start the Update
E
Fig.9.9: Firmware update II
Another window now opens. A list shows all the firmware files
available on the SD card. Normally however there is only one file
available.
swf_D-ISC_100:fw_01.01R0000.drg
Fig.9.10: Firmware file list
Use the arrow keys (
) to select the desired firmware file and
confirm the selection by pressing the
key.
Firmware update
Status: S1.3:Normal measurement
Menu: 3.6
Please press RETURN key to start the update.
Updating application code
Open swf_D-ISC_100_fw_01.01R0000.drg
Loading 100 %
Erasing 100 %
Writing 100 %
Flash device: application code updated
Please press RETURN key to reboot.
E
Fig.9.11: Firmware update III
The update process starts. The progress is shown in the window.
The procedure requires some time. The system then reports that
the update process and has been closed. Press the
key once
again to restart the device.
This completes the firmware update. Once the Universal control
unit has been re-initialised after restarting, it will then be working
with the new firmware.