Safety instructions
Operating manual 171/173 Version 01.0 - 01/201614
Operator's
obligations
Observe the country-specific safety and accident prevention
regulations and the legal regulations concerning industrial safety
and the protection of the environment.
All warnings and safety signs on the machine must always be in
l
egible condition and may not be removed. Missing or damaged
labels must be replaced immediately.
Requirements to
be met by the
personnel
The machine may only be set up by qualified specialists.
Maintenance work and repairs may only be carried out by qualified
specialists.
Work on electrical equipment may only be carried out by qualified
specialists.
Only authorized persons may work on the machine. Every person
wh
o works on the machine must have read the operating manual
first.
Operation Inspect the machine while in use for any externally visible damage.
Interrup
t your work if you notice any changes to the machine.
Report any changes to your supervisor. A damaged machine must
not be used any further.
Safety
equipment
Safety equipment may not be removed or put out of service. If this
cannot be avoided for a repair operation, the safety equipment
must be refitted and put back into service immediately afterwards.
To Next Page
Loading...
