DURKOPP ADLER 171 - Removing the Transport Securing Devices

Set-up
Operating manual 171/173 Version 01.0 - 01/201654
Maximum delivery scope:
• Upper section of the machine (1) with sewing drive
• Table plate (2)
•Oil pan (not shown) - in the accessory pack
•Drawer (3)
• Frame (4)
• Pedal (5) with rod
• Setpoint device (6) with rod
• Pneumatic maintenance unit (7)
• Controller (8)
• Control panel for DAC classic (not shown)
• Reel stand with unwinding bracket (9) - in the accessory pack
• Small parts in an accessory pack
6.2 Removing the transport securing devices
All transport securing devices must be removed prior to set-up.
1. Remove the lashing straps and
wooden blocks from
the machine upper section, the table and the frame.
2. Remove the supporting wedges between the machine
arm and throat plate.