Set-up
Operating manual 171/173 Version 01.0 - 01/2016 59
6.6 Setting the working height
The working height can be adjusted continuously between
750 and 900 mm (clearance between the floor and upper
e
dge of the table plate).
Fig. 37: Setting the working height
1. Loosen all four screws (1) on the head sections.
2. Set the table plate to
the desired height.
Important: Pull
out or push in the table plate evenly at both
sides to prevent it from jamming.
3. Tighten the screws (1) on the head sections.
To Next Page
Loading...
