DURKOPP ADLER 171 - Checking the Pneumatic System

Operation
Operating manual 171/173 Version 01.0 - 01/201646
Cleaning steps
1. Switch off the power supply at the main switch.
2. Remove any sewing dust and thread remains using
a compressed-air pistol or a brush.
3. Remove any sewing dust and cutoffs from the oil pan.
5.16 Checking the pneumatic system
Fig. 28: Pressure indicator on the maintenance unit
Check the pressure:
1. Check the pressure on the pressure indicator (2) each day.
Reference value: 6 bar.
Important: T
he pressure must not deviate from the reference
pressure by more than 1 bar.
Possible damage to the paintwork from solvent-based
cleaners.
Solvent-based cleaners damage the paintwork of the machine.
Use only solvent-free substances when wiping down the machine.
ATTENTION
0
2
8
4
6
10
1
2
(1) - Reference value: 6 bar
(2) - Pressure indicator
Machine damage possible due to incorrect pressure.
Incorrect pressure can cause damage to the machine.
Check the pressure on a daily basis.
Have the pressure adjusted by qualified specialists
if the pressure deviates from the reference value.
ATTENTION