Set-up
Operating manual 171/173 Version 01.0 - 01/2016 65
6.11 Fitting the knee lever
The machine has a mechanical knee lever, depending on the
submodel and equipment.
Fig. 44: Fitting the mechanical knee lever
1. Tilt the upper part of the machine backwards.
2. Fit the transmission rod (3) in the oil pan.
3. Screw the knee lever (1) rods together.
4. Guide the rod (1) through the hole in the oil pan (2)
and connect it to the transmission rod (3).
(1) - Knee lever rod (2) - Hole in the oil pan
(3) - Transmission rod
To Next Page
Loading...
