About this operating manual
Operating manual 171/173 Version 01.0 - 01/2016 5
1.5 Liability
All information and notes in this operating manual have been
compiled in accordance with the latest technology and the appli-
cable standards and regulations.
The manufacturer cannot be held liable for any damage due to:
• Damage during transport
• Failure to observe the operating manual
• Improper use
• Unauthorized modifications to the machine
• The deployment of untrained personnel
• Using unapproved spare parts
1.5.1 Transportation
Dürkopp Adler cannot be held liable for any damage during trans-
port. Check the delivered product immediately after receiving it.
Report any damage to the last transport manager. This also
applies if the packaging is not damaged.
Keep the machines, devices and packaging material in the con-
dition they were at the time when the damage was identified.
Th
is secures any claims towards the transport company.
Report all other complaints to Dürkopp Adler immediately after
re
ceiving the product.
1.5.2 Intended use
The Dürkopp Adler 171/173 is for sewing light to moderately
heavy material. The material may not be thicker than 4 mm,
wh
en it is pressed together by the lowe
red sewing feet.
Intended thread strengths:
•70/3 Nm (core spun thread)
The material must contain no hard objects.
The machine is only intended for processing dry material.
The machine may only be set up and operated in dry conditions
o
n well-maintained premises. If the machine is operated on prem-
ises that are not dry and well-maintained, then further measures
may be required which must be compatible with EN 60204-31:1999.
The sewing machine is intended for industrial use.
To Next Page
Loading...
Need help?
General
