Set-up
Operating manual 171/173 Version 01.0 - 01/201664
6.10 Fitting the pedal and setpoint device
Fig. 43: Fitting the pedal and setpoint device
1. Place the pedal (5) on the cross strut (6) and align it in such
a way that the middle of the pedal is under the needle. The
cross strut has elongated holes to allow alignment of the pedal.
2. Screw the pedal (5) firmly onto the cross
strut (6).
3. Screw the setpoint device (2) onto the bracket (1).
4. Screw the bracket (1) under the table plate so that the pedal
ro
d (4) runs to the pedal (5) at right-angles to the setpoint
device (2).
5. Hang the pedal rod (4) with the ball socket on the setpoint
device (2) and the pedal (5).
6. Pull the pedal rod (4) to the correct length:
Correct setting: 1
0° inclination with pedal (5) released
7. Tighten the screw (3).
(1) - Bracket
(2) - Setpoint device
(3) - Screw
(4) - Pedal rod
(5) - Pedal
(6) - Cross strut
①
④
②
⑤
③
⑥
To Next Page
Loading...
