Set-up
Operating manual 171/173 Version 01.0 - 01/2016 63
Fig. 42: Laying the control panel cable
Laying the control panel cable
6. Laying the cable behind the rear of the arm cover.
Important: Note th
e different cable inlets (7) of the 171
and 173.
7. Guide the cable down under the handwheel cover.
8. Feed the cable through the table plate cutout downwards
to the controller.
Important: Lay and
secure the cable such that it does
not come into contact with any moving parts.
9. Screw the arm cover including control panel tight.
10. Position the handwheel and handwheel cover and screw tight.
(7) - Cable inlet
Cable guide 171 Cable guide 173
⑦
To Next Page
Loading...
