DURKOPP ADLER 580 - Menu Item Step Motor Test

29.6.5 Menu item step motor test
With this menu item the step motors can be checked.
The step motors are checked with the related reference switches.
Attention: Danger of breakage!
Before starting the step motor test remove the clamping plates in any
case.
Caution: Danger of injury!
Exercise utmost caution when making the step motor test.
–
Select the corresponding step motor X...Z with the keys “ß”or“à”.
–
With the keys “á”or“â” the step motor runs each 20 steps
forwards or backwards.
X = X-direction (transversal motion of the fabric support plate)
Y = Y-direction (longitudinal motion of the fabric support plate)
Z = Z-direction (rotary motion of the sewing works)
–
Quit the step motor test by pressing the “ESC”key.
3
101