10.5.1 Adjusting the cutting block position (Multiflex system)
Caution: Danger of injury !
Turnthemainswitchoff.
Adjust the cutting block position only with the machine switched off.
The knife 5 has on each side two marks and a number marked.
The setting positions for a 10 mm cutting block are situated on one
side and on the other side for a 17 mm cutting block.
The setting of the 17 mm cutting block will be explained here.
Standard checking
If the cutting block 3 is located at its right end position (picture on the
left), its left edge should stand on the right line 4 of the knife.
If the cutting block 3 is located at its left end position (picture on the
right), its left edge 7 should stand on the left line 8 of the knife.
Correction
–
Disconnect the machine from the pneumatic supply system.
–
Push the cutting block holder 6 downward, until it lays on the knife.
–
Push the cutting block to its right end position.
The left edge of the cutting block must stand on the right line 4 of
the knife.
–
Loosen the screw 2.
–
Adjust the position of the left cutting block edge by means of the
screw 1.
–
Tighten the screw 2 again.
39
3
54 3 21 876
To Next Page
Loading...
