10.4 Adjusting the knife parallel to the cutting block with “Multiflex” machines
Caution: Danger of injury !
Turn off the main switch.
Adjust the knife only with the machine switched off.
Correction w ith t he subclasses 580-312000 and 580-321000
–
Disconnect the machine from the pneumatic supply system.
–
Move the carriage in a way that the screw 1 can be unfastened
witha2mmAllenkey.
–
Loosen screws 2 and 3.
–
Put the key 4 (in the accessories) on the hexagonal bolt 5 and
twist it.
–
Push the cutting block 6 downward.
–
Check whether the cutting block 6 is in parallel position to
the knife 7.
–
Tighten the screws 1, 2 and 3 again.
–
Connect the machine to the pneumatic supply system again.
37
3
321
7654
To Next Page
Loading...
