10.6 Setting the switch for the “Multiflex” cutting system
Caution: Danger of injury !
Turnthemainswitchoff.
Set the switch for the cutting system only with the machine
switched off.
Standard checking
When the cutting block is at its upper position, the lower edge 2 of the
fork 1 should be on the same level as the lower edge of the switch 3.
There must be a distance of 2 mm between the switch 3 and the fork 1.
Correcting the sw itch height
–
Loosen screw 5.
–
Shift the plate 4 with the switch 3 upward.
–
Tighten screw 5.
Correction distance betw een the sw itch and the fork
–
Loosen the counter nut 6.
–
Set the switch 3 and the nut 7 in a way that a 2 mm distance is
kept.
–
Tighten the counter nut 6.
43
3
763 2 1
543
To Next Page
Loading...
