DURKOPP ADLER 580 - 20 Adjusting the Fabric Clamps

20. Adjusting the fabric clamps
Caution: Danger of injury!
Turnthemainswitchoff.
Adjust the fabric clamps only with the machine switched off.
Standard checking
Between the needle 2 and the upper fabric clamp 1 there should be a
distance of 1 mm over the whole length and in the eyelet.
–
Insert the clamping plates.
–
Insert a new needle.
–
Switch the machine on.
–
Press key “F”.
–
Enter code “2548”.
–
Press key “OK”.
The control switches to the technician level.
–
Select menu “Test functions”.
–
Press key “OK”.
–
Select menu “Multitest”.
–
Press key “OK”.
–
Select menu “Output test”.
–
Press key “OK”.
–
Select function “Y03” (closing the fabric clamp).
–
Press key ”OK”.
The fabric clamps close.
–
Select function “Y04”.
–
Press key ”OK”.
The clamping plates spread.
–
Check the distance between upper fabric clamp 1 and needle 2.
56
21 65 4 7 3
3