Index Page:
Part 3: Service Instructions Class 580
1. General notes
1.1 Necessaryprogramsetting......................................... 5
2. Adjusting the locking positions
2.1 General notes ................................................. 6
2.2 Looper and spreader eccentric....................................... 7
2.3 Threadtake-updisc............................................. 8
2.4 Throweccentric................................................ 9
3. Needle bar positioning ........................................... 10
4. Aligning the looper turret ......................................... 12
5. Aligning the needle bar parallel to the looper turret ........................ 15
6. Transversal motion of the fabric support plate ........................... 17
7. Longitudinal motion of the fabric support plate ........................... 19
8. Clamping plates
8.1 Insertedclampingplates .......................................... 21
8.2 Aligningtheclampingplates........................................ 22
8.3 Adjusting the spreading ........................................... 23
8.4 Heightofthefabricclamps......................................... 25
8.5 Adjustingthelockingplate......................................... 26
8.6 Lockingoftheclampingplates....................................... 27
8.7 Adjustingthefabricclampingpressure.................................. 28
9. Adjusting the seam w idth
9.1 Presettingtheseamwidth ......................................... 29
9.2 Needle zero position ............................................. 32
10. Cutting knife (eyelet knife)
10.1 Positionofthecuttingknife......................................... 33
10.2 Settingdimensions.............................................. 35
10.3 Adjustingtheknifeparalleltothecuttingblock............................. 36
10.4 Adjustingtheknifeparalleltothecuttingblockwith“Multiflex”machines............. 37
10.5 Cuttingblockadjustment.......................................... 38
10.5.1Adjustingthecuttingblockposition(Multiflexsystem)......................... 39
10.6 Settingtheswitchforthe“Multiflex”cuttingsystem .......................... 43
10.7 Cuttingpressure ............................................... 44
10.8 Cuttingduration................................................ 44
3
To Next Page
Loading...
