DURKOPP ADLER 580 - Adjusting Locking Positions

Index Page:
11. Looper height ................................................ 45
12. Adjusting the loop stroke ......................................... 46
13. Needle bar height .............................................. 48
14. Distance betw een looper and needle .................................. 49
15. Needle protection .............................................. 50
16. Spreader.................................................... 51
17. Spreader plate ................................................ 52
18. Throat plate .................................................. 53
19. Adjusting the needle thread knife .................................... 54
20. Adjusting the fabric clamps ....................................... 56
21. Thread take-up spring ........................................... 58
22. Short trimmer for low er thread (580-112000, 580-312000)
22.1 Function sequence .............................................. 59
22.2 Initialposition................................................. 61
22.3 Adjustingthecuttingpressure/clampingpressure .......................... 63
22.4 Knife change ................................................. 64
23. Long trimmer for looper thread and gimp (580-121000 und -321000)
23.1 Cuttingpressureandcuttingmotion ................................... 65
23.2 Adjustingtheknifeoverlap......................................... 66
23.3 Position of the looper thread and gimp clamp .............................. 69
23.4 Threaddeflector ............................................... 70
24. Short trimmer for looper thread and gimp (580-141000)
24.1 Optional equipment for subclass 580-141000 .............................. 74
25. Gimp pulling device for subclass 580-141000 ............................ 75
26. Thread catcher
26.1 General notes ................................................. 76
26.2 Adjustment................................................... 77
26.3 Subsequent fitting of the thread catcher ................................. 79
27. Maintenance ................................................. 80
28. Annex
28.1 Adjusting operations without head cover ................................. 81