29.4 Menu items configuration automatic buttonholer
29.4.1 Loading position (Load.pos.)
Via this menu item the desired loading position can be set.
Input: 0 … 68 (mm)
Standard: 68
The value entered corresponds to the distance from the cutting point.
The value “0” corresponds to the cutting-open position.
The standard value is identical with the seam beginning position.
29.4.2 Menu item throw width (Zig Zag)
In this menu the throw width can be checked and with eyelet machines
itcanalsobeset.
Caution: Danger of breakage !
The throw width must match the mechanical position
of the throw eccentric.
See chapter 2.3
Input: 1 = Narrow
2=Wide
88
To Next Page
Loading...
