DURKOPP ADLER 580 - Aligning the Clamping Plates

8.2 Aligning the clamping plates
Caution: Danger of injury!
Turnthemainswitchoff.
Adjust the clamping plates only with the machine switched off.
Standard checking
Both clamping plates 3 must be adjusted in such a way that the
distance between clamping plate and fabric support plate 1 is
equal on the entire length (distance X1 = distance X2).
–
Put on the right clamping plate.
–
Check distance X1 and X2.
Correction
–
Insert the right clamping plate.
–
Loosen the screw 4 with an Allen key.
–
Turn the eccentric 2 correspondingly.
–
Tighten the screw 4.
–
Insert and adjust the left clamping plate.
22
4
321
X1
X2