Dynapac F 161 W - Page 186

F 7.3 4
F_7.3_01_GB.fm 4-6
Drive shaft (2)
- For the oil level check unscrew the
dipstick (A) on the upper side of the
drive shaft.
A
The oil level shall be at the upper mark.
For filling in the oil:
- Remove the dipstick (A).
- Fill in the specified oil through the fill-
ing port (B) until the required filling lev-
el is achieved on the dipstick.
- Replace the dipstick (A).
Oil change:
A
Change the oil when the engine is at op-
erating temperature
- Remove the cover cap of the oil drain
port (C) and screw on the hose provid-
ed as an accessory.
- Place the end of the hose in a dish to
catch the oil.
- Open the shutoff valve with a spanner
and let the oil fully drain.
- Shut off the valve, remove the hose
and return the cover cap.
- Fill in the specified oil through the fill-
ing port (B) until the required filling lev-
el is achieved on the dipstick.
- Replace the dipstick (A).
F0017_A1.TIF/F0113_B1.Tif
A
B
C