MK-6 Operation Manual 127
Programming Basics
Stereo Mix Outputs
Stereo Mix
Outputs
This feature is useful for adding signal processing (EQ, reverb, etc.) of
individual sounds prior to final mixdown.
The routing can be performed according to MIDI channel from the Mix
Output screen in the Global menu. Simply assign each channel to the
desired output.
To route a particular preset to a Send, first go to the Mix Output screen in
the Global menu and set the MIDI channel to “use preset”.
Next set the Mix Output routing in the preset to the desired output (for
each layer). Yes, you can send each layer to a different send if you want.
By sending different amounts of presets to the effects, subtle or striking
effects can be achieved using the two effect processors. This feature allows
you to get the most out of two effects since you can have eight different
mixes.
For more information, refer to the diagram on the following page or, See
“Mix Output” on page 86.
MIX OUTPUT
channel 01: Send 1->main
Global
Menu
MIX OUTPUT
channel 01: use preset
Global
Menu
L1
MIX OUTPUT
Send 2 -> main
Preset Edit
Menu
To Next Page
Loading...
General