194 E-MU Systems
Save/Copy Menu
Duplicate Flash
Duplicate Flash This utility allows you to duplicate Flash SIMMs using MK-6. Both Sound
and Preset data is copied when a Flash SIMM is duplicated. A factory sound
SIMM cannot be copied using this utility.
The SIMM sockets are marked 0, 1, 2, 3. The Flash SIMM you want to copy
MUST be placed into SIMM Socket 0. The destination Flash SIMM must be
placed in SIMM socket 1. See “Installing Sound SIMMs” on page 238.
1. Make sure the two Flash SIMM are located in the required SIMM
sockets.
__
__
If there are no Flash
SIMMs in the unit, or if the
SIMMs are in the wrong slots,
an error message will be
displayed.
2. Press the Save/Copy menu button.
3. Rotate the data entry control to select the “Duplicate Flash SIMM”
screen shown above.
4. Move the cursor to the bottom line and press Enter. The following
screen appears and the Enter LED will be flashing.
5. Press Enter again to confirm or any other button to abort. The
following screen appears and the SIMM is copied.
6. When MK-6 has finished duplicating the SIMM, turn power off, remove
the copied SIMM, then reboot. That’s it!
DUPLICATE SLOT 0 FLASH
Start
Press ENTER to overwrite
the Flash SIMM in Slot 1
DUPLICATING SLOT 0 -> SLOT 1
(Takes about 5 minutes)
To Next Page
Loading...
General