54 E-MU Systems
Arp/Beats Menu
Beats
Beats Part Group This screen is where you assign Parts to one of the four Groups. By
grouping, you can play multiple parts with a single key. A part can be in
one and only one group, or in no groups.
To Assign a Part to a Group:
__
__
All Parts assigned to a
Group will stop playing when
the Group key is triggered, then
untriggered even if the individual
Parts in the Group are latched.
1. Press the left cursor button to move the cursor under the Part field.
2. Select the Part number using the Data Entry Control. Parts 1-16 can be
selected. (All parts, shown as an “A”, can be edited at once if “Edit All
Layers” is enabled in the Master menu.)
3. Move the cursor to the bottom line using the cursor keys and select the
Group (1-4 or none) using the Data Entry Control.
4. Repeat steps 1 through 3 for all the Parts you wish to assign.
5. Press the Enter/Home button or use the cursor keys to move the cursor
back to the screen heading.
Master Riff The Master Riff is selected from this screen. The Master Riff is used when
Master (M) is selected for Beats in Beats mode enable screen.
To Assign the Master Riff:
1. Use the cursor buttons to move the cursor to the lower line of the
display.
2. Select the desired Riff using the Data Entry Control. (Beats Riffs are
identified by the bts: prefix.)
3. If there is more than one ROM in MK-6 you can select Riffs from either
ROM set. Move the cursor under the ROM ID and select using the Data
Entry Control.
4. Press the Enter/Home button or use the cursor keys to move the cursor
back to the screen heading.
P1
BEATS PART GROUP
Group: 2
Select Part
Plays: KEY-C3
MASTER RIFF MROM1
To Next Page
Loading...
General