192 E-MU Systems
Save/Copy Menu
Copy Preset Bank
Sound
Authoring
This is a special purpose function to be used with the Flash sound
authoring feature. Flash Sound SIMMs created on an EOS Ultra sampler can
be used as a custom MK-6 bank. Presets are then created in a User bank.
When the bank of presets is finished, it can be copied, using this function,
to the Flash SIMM. Flash SIMMs contain two separate memory locations.
One of these memories contains the sound samples and the other memory
can hold four banks of 128 presets.
For instructions on how to remove and replace ROM SIMMs,
please see “Installing Sound SIMMs” on page 238
.
The four sound SIMM sockets in MK-6 are marked 0-3. The destination
Flash SIMM must be placed in SIMM socket 1.
To Copy a User Bank to Flash:
1. Make sure a Flash SIMM is inserted into the extra MK-6 SIMM socket.
__
__
If there is no Flash SIMM
in the unit, the error message,
“Requires Flash SIMM” will be
displayed.
2. Press the Save/Copy menu button.
3. Rotate the data entry control to select the “Copy User Bank” function
shown above.
4. Move the cursor to the “From” field and select the User bank that you
want to copy to the Flash SIMM.
5. Move the cursor to the “To” field and select the Flash bank that you
want to contain the User bank.
6. Press Enter. The Enter LED will flash and the screen below appears.
7. Press Enter again to confirm. The following screen appears:
8. The Flash presets cannot be used until MK-6 is rebooted (power off then
on). Reboot the MK-6 and verify that the new Flash bank has been
properly copied.
Copy User Bank
to Flash
COPY USER BANK TO FLASH
From: User
0
To: Flash
2
Press ENTER to Overwrite
Flash SIMM Presets
COPYING USER BANK TO FLASH
Done. Please Reboot Now.
To Next Page
Loading...
General