MK-6 Operation Manual 27
Instant Gratification
Multi-Channel Arpeggiator
11. Move the cursor underneath the Category field (as shown above) and
select the “arp” category.
12. Move the cursor underneath the preset name and select any “arp”
preset for channel 1.
13. Press the “+” Channel select button (located to the left of the LCD), so
that C02 is displayed.
14. Select any other “arp” preset for channel 2.
15. Select channel 03 and choose another arp preset.
Select Trigger Mode
16. Press the Selector Button in the upper left corner of the Command
Functions section. Pressing this button will switch between Track
Enable/Mute and Triggers mode. Select Triggers mode.
Play it!
17. Now press Trigger Buttons 1, 2 and 3. You should be hearing three
arpeggiators playing at once.
18. Change the arp preset on the current MIDI channel. Since the cursor is
located on the preset name, all your selections will be in the arp
category.
19. Press the Channel button and change the arp presets for channels 1, 2
& 3. Since each factory preset has differently programmed arpeggiator
settings, changing the preset not only changes the sound, but the
arpeggiator as well.
20. You can also play the keyboard. You’ll be playing the preset currently
showing in the display.
21. Adjusting the front panel Controller Knobs modifies the preset
showing in the LCD.
22. Press the M-P button in the Controllers section to select the Arp control
functions. Adjust the Arp Velocity and Arp Gate Time. Then change
the MIDI channel and do it for another arp pattern.
OO
OO
Sometimes a simple
volume change will bring out
hidden voices and patterns.
23. Press the Mix button so that “VOLUMES” is selected. This screen lets
you blend the volume of every arpeggiator preset.
There’s lots more to the arpeggiators. To find out more, refer to the
arpeggiator chapter beginning on page 43.
C01 V127 P00 A:P MROM1
026
3
arp:Hollographik
To Next Page
Loading...
General