Eaton 93E MK2 - Completing the Installation Checklist

Installation Checklist
 All packing materials and restraints have been removed from each cabinet.


The UPS cabinet is placed in its installed location. Refrain from installing UPS direct under Air con duct.


All conduits and cables are properly routed to the UPS and any ancillary cabinets.


All power cables are properly sized and terminated.


Neutral conductors are inst alled.


A ground conductor is properly inst alled.


Building alarms are wired appropriately. (Optional)


LAN drops are installed. (Optional)


LAN connections have been completed. (Optional)


The REPO device is mounted in its installed location and its wiring is terminated inside the UPS
cabinet. (Optional)


A jumper wire is connected between pins 3 and 4 on the REPO terminal block if using a normally-
closed
REPO switc h. (Optional)


All terminal cover plates are inst alled.


A ccessories are mounted in installed locations and wiring is terminated inside the UPS cabinet.
(Optional)


Air conditioning equipment is installed and operating correctly .


The area around the installed UPS system is clean and dust-free. (Eaton recommends that the UPS
be installed on
a level floor suitable for computer or electronic equipment.)


A dequate workspace exists around the UPS and other cabinets.


A dequate lighting is provided around all UPS equipment.


A 230 Vac service outlet is located within 7.5 meters (25 feet) of the UPS equipment.


Startup and operational checks are performed by an authorized Eaton Customer Service Engineer, for
parallel
sy stems or installations with accessory cabinets.
Parallel System Installation Checklist
 Each cabinet in the parallel system is placed in its installed location. Refrain from installing UPS direct
under Air con duct.


All conduits and cables are properly routed to the UPSs and to the parallel tie cabinet.


All power cables are properly sized and terminated.


Neutral conductors are installed between cabinets as required.


Ground conductors are properly inst alled.


CAN wiring between the UPSs is properly inst alled.


Pull chain wiring between the UPSs is properly inst alled.


A dequate workspace exists around the UPSs, parallel tie cabinet, and other cabinets.


Startup and operational checks are performed by an authorized Eaton Customer Service Engineer, for
parallel
sy stems.
38
Eaton 93E MK2 UPS (10-40kVA, 380/400/415V) Installation and Operation