Eaton 93E MK2 - Communication; Mini-Slot Cards; Figure 7-1. Optional Mini-Slot Cards

gement Card and
Chapter 7 Communication
This chapter describes the communication features of the Eaton 93E UPS. For terminal wiring information, see
paragraph 3.2.3 and paragraph 4.4. For location of the customer interface panel and terminals, see Figure 4-6
and Figure 4- 7.
7.1 Mini-Slot Cards
The Eaton 93E UPS has two standard, factory-installed Mini-Slot communication bays. See Figure 4-7 for ba y
locations. The UPS is compatible with the following Mini-Slot cards (see Figure 7-1):
• Network Management Card and Modbus/Jbus – provides remote monitoring through a Web bro wser
interface, e-mail, and a network management system (NMS) using SNMP and connects to a t wisted-pair
Ethernet (10/100BaseT)
net w ork. The card also provides direct integration of UPS information (meters and
status) to a Building Management System (BMS) using the Modbus RTU protocol.
• Network Management Card – provides remote monitoring through a Web browser interface, e-mail, and a
network management system
(NMS) using SNMP and connects to a twisted-pair Ethernet (1 0/1 0 0B aseT)
net w ork.
• Management Card Contact and RS232 / Serial – two types of interfaces via a DB9 connector are a v ailable
with this card. Dry contact mode provides a simple way to transmit UPS information to an alarm sy stem,
PLC, or
computer system via dry relay cont acts. The transmitted information is load powered, load on b ypass,
load on battery, load on utility, battery fault, and low battery. RS232 mode provides an RS232 interface f or
connection to a PC or to a UPS Control display unit. Jumpers are used to select the interface (contacts or
R S232).
LAN and telephone drops for use with Mini-Slot connectivity cards must be supplied by facility planners or the
customer .
For installation and
setup of a Mini-Slot card, contact an Eaton service representative (see paragraph 1.8). R efer
to the manual supplied with the Mini-Slot card for user instr uctions.
Management Card Contact and
RS232/Serial
Network Management Card and
Modbus/Jbus
Network Management Card
Figure 7-1. Optional Mini-Slot Cards
7-1
Eaton 93E MK2 UPS (10-40kVA, 380/400/415V) Installation and Operation