Eaton 93E MK2 - Using the Remote Emergency Power-Off Switch

6.3.13 Using the Remote Emergency Power-off Switch
A UPS emergency power-off is initiated by the REPO pushbutton switch. In an emergency, you can use this switch to
control the UPS
output. The REPO switch de-energizes the critical load and powers down the UPS immediately, without
asking for v erification.
The UPS, including
Bypass, remains off until rest arted.
CAUTION
All power to the critical load is lost when the REPO switch is activated in the following step. You should use this
feature only when you want to de-energies the critical load.
NOTE
The follow
ing
instructions are for the Eaton-supplied REPO switch. If a customer-
supplied REPO switch is used, it may not activate in the same manner; refer to the
operating instructions provided with the switc h.
64
Eaton 93E MK2 UPS (10-40kVA, 380/400/415V) Installation and Operation