Eaton 93E MK2 - Page 75

To use the REPO switc h:
1. Firmly push the red
pushbutton until it locks into place. The switch latches into the activated st ate.
The input, output, battery, and bypass backfeed contactors open, and the power module is turned of f
immediately, without asking for v erification.
CAUTION
Do not attempt to restart the system after the REPO until the cause of the shutdown has been
identified and cleared.
2. To
deactivate the REPO switch in preparation for restarting the UPS, insert the supplied key and rot ate
clockwise until the red pushbutton releases. To remove the key, rotate the key back to the vertical position.
3. Restart the UPS by following the procedure in paragraph 6.3.1 or 6.3.2.
65
Eaton 93E MK2 UPS (10-40kVA, 380/400/415V) Installation and Operation