Eaton 93E MK2 - Transfer from Bypass to Normal Mode; Transfer from Standard Normal Mode to HE Mode; Transfer from HE Mode to Standard Normal Mode

W ARNING
Power is present inside the UPS cabinet.
6.3.4
Transfer from Bypass to Normal Mode
To transfer the critical load to Normal mode:
1.
Select the CONTROLS symbol on the main menu bar. The System Control screen is displa y ed.
2. If not already selected, select UPS on the System Control screen.
3. On the UPS System Control screen, select the BYPASS NORMAL command, then press the RETURN
pushbut ton.
The UPS transfers to Normal mode. If the power module is not available, the system remains on b ypass
and an alarm sounds.
The NORMAL status indicator is illuminated.
6.3.5 Transfer from Standard Normal Mode to HE mode
To transfer the load to HE mode:
1.
Select the CONTROLS symbol on the main menu bar. The System Control screen is displa y ed.
2. If not already selected, select UPS on the System Control screen.
3. On the UPS System Control screen, select the HE: DISABLE ENABLE command, then press the
RETURN
pushbut ton.
After battery is fully charged, the UPS transfers to HE mode if no abnormal power conditions are detected.
If abnormal power conditions are detected, the UPS will wait and transfer to HE mode when conditions are
cleared.
The NORMAL status indicator is illuminated.
6.3.6 Transfer from HE Mode to Standard Normal Mode
To transfer the load to Standard Normal mode:
1.
Select the CONTROLS symbol on the main menu bar. The System Control screen is displa y ed.
2. If not already selected, select UPS on the System Control screen.
3. On the UPS System Control screen, select the HE: ENABLE DISABLE command, then press the
RETURN
pushbut ton.
The UPS transfers to Standard Normal mode.
The NORMAL status indicator is illuminated.
60
Eaton 93E MK2 UPS (10-40kVA, 380/400/415V) Installation and Operation