Eaton 93E MK2 - Installing Batteries; Recycling the Used Battery or UPS; Maintenance Training

UPS Maintenance
8.3 Installing Batteries
NOTE
There is no manual DC disconnect device within the UPS .
Install
batteries in accordance with the battery and battery system manufacturer's instr uctions.
8.4 Recycling the Used Battery or UPS
Contact your local recycling or hazardous waste center for information on proper disposal of the used battery or
UPS .
W ARNING
• Do not dispose of the battery or batteries in a fire. Batteries may explode. Proper disposal of
batteries is required. Refer to your local codes for disposal requirements.
• Do not open or mutilate the battery or batteries. Released electrolyte is harmful to the skin and
eyes. It may be to xic.
• A battery can cause electrical shock, burn from high short-circuit current, or fire. Observe proper
precautions.
CAUTION
Do not discard the UPS or the UPS batteries in the trash. This product contains sealed, lead-acid
batteries and must be disposed of properly. For more information, contact your local recy cling/
reuse or hazardous waste center.
CAUTION
Do not discard waste electrical or electronic equipment (WEEE) in the trash. For proper disposal,
contact your local recycling/reuse or hazardous waste center.
8.5 Maintenance T raining
A basic training course, available from Eaton Corporation, gives you a competent working knowledge of the
UPS system operation and teaches you how to perform first level corrective maintenance. For more
information about training and other services, contact the Help Desk (see paragraph 1 .8).
80
Eaton 93E MK2 UPS (10-40kVA, 380/400/415V) Installation and Operation